In the process of use, it can better realize the grinding of multi-level holes such as the end face, clamping and inner hole. The guide rail of the equipment has high precision and has vibration resistance during operation. In the process of processing, it is generally used to grind some large parts. In the process of use, the inner holes and end faces of the parts are mainly ground. Because the equipment is numerically controlled, it can reach many of its parts. Processing requirements.
In the process of operating a large vertical lathe, you should pay attention to:
1. The rough surface of the workpiece is not allowed to be directly placed on the work surface, and should be supported by a shim or screw top; it is strictly forbidden to use the work surface to perform other operations such as hammering to correct the workpiece, welding the workpiece, etc.
2. When aligning the workpiece, only jog the worktable to rotate at low speed for alignment, and high-speed alignment is not allowed.
3. When starting and stopping the workbench, the start and stop handle of the workbench can only be moved by hand, and pedaling is strictly prohibited.
4. When the worktable is rotating, it is not allowed to do the lifting of the beam and the rapid movement of the tool post.
5. When moving the beam, the clamping device must be released first, and the clamping device should be clamped immediately after the movement is completed. Each time the beam is lowered, it should rise a little to eliminate the gap between the lead screw and the nut.
6. Gravity cutting processing is not allowed when the ram of the hanging frame and the side tool post extend very long; when using the hanging frame for processing, especially for gravity cutting, the beam should be lowered as close to the working position as possible .
7. When doing intermittent cutting, appropriately reduce the amount of feed and table speed.
8. The joystick must be pushed to the specified position when shifting. If the gear is not meshed well, it should be adjusted by fine movement after work, and forced operation is not allowed.
Hope that the above content can help everyone to better understand this equipment.