In the use of hydraulic presses, in addition to paying attention to operating standards and punctual repairs and maintenance, we also need to think of ways to increase the operating power of hydraulic presses, so how to increase the operating power of hydraulic press equipment? The following editor gives you a brief introduction:
1. The operator of the hydraulic press must understand the principle of the hydraulic press, understand the effects of the main hydraulic components of the equipment, and grasp the sequence of system operation.
2. Before starting the equipment, check whether all the movement organization and solenoid valve are in the original condition, check the oil level of the fuel tank, if an abnormality or lack of oil is found, stop starting the hydraulic pump motor and find a repairer to repair it.
3. The operator should always check the working condition of the hydraulic press, observe the working pressure and speed, check the size of the workpiece and the wear condition of the props, to ensure the stability of the hydraulic press.
4. In winter, when the oil temperature of the fuel tank does not reach 25°C, the fulfillment organizations cannot start to work in sequence, but can only start the hydraulic pump motor to make the hydraulic pump empty. During summer work, when the oil temperature in the fuel tank is higher than 60°C, pay attention to investigate the operating conditions of the hydraulic press and tell the repairer to deal with it.
5. The operator cannot damage the interlocking equipment of the electrical system, cannot push the electric control valve by hand, or damage or move the position of each operating gear arbitrarily.
6. For hydraulic equipment that has been shut down for more than 4 hours, before starting work, the hydraulic pump motor should be started for 5-10 minutes before working under pressure.
7. When the hydraulic machine is faulty, the operator should not move without permission and should immediately report to the repair department.
8. Always adhere to the cleaning of hydraulic equipment to avoid dust, cutting fluid for cutting, cutting, cotton yarn and other debris from entering the oil tank.
The above is the specific method to improve the working power of hydraulic equipment.